Pull it all the way through from the front side of the brick until the LED component is sitting nicely in the inside of the brick.

Start by removing the following pieces to allow us to then remove one of the headlight sections as per below.Ģ.) Disassemble the headlight piece and then take one bit light with 30cm cable and thread the connector side of the cable through the back of the white 1×1 brick with hole. You can either place them directly on top of LEGO® studs or in between.ġ.) We will start with installing headlights to Ecto-1. When installing Bit Lights under LEGO® pieces, ensure they are placed the correct way up (Yellow LED component exposed). Installing Bit Lights under LEGO® bricks and plates. WARNING: Incorrectly inserting the connector can result in bent pins inside the port or possible overheating of the expansion board when connected. If a plug won’t fit easily into a port connector, do not force it. The connector side with the wires exposed should be facing toward the soldered “=” symbol as you insert into the port. With the expansion board facing up, look for the soldered “=” symbol on the left side of the port. Take extra care when inserting connectors to ports of Expansion Boards. Connecting cable connectors to Expansion Boards Do NOT forcefully join LEGO® together around cables instead ensure they are laying comfortably in between each stud.ĬAUTION: Forcing LEGO® to connect over a cable can result in damaging the cable and light.

Important things to note: Laying cables in between and underneath bricksĬables can fit in between and underneath LEGO® bricks, plates, and tiles providing they are laid correctly between the LEGO® studs. 1x Flat Battery Pack (Requires 2x CR2032 batteries).

Please read and follow the steps carefully to ensure this lighting kit is installed properly. Here is the instructions document for the Lego Ecto-1 & 8 LED lighting kit.

Lego ecto one light kit